1. Make sure all parts are included. You should have:
a. An optics mount
b. 4x mount mounting screws (flat head, torx drive screws)
c. 2x optics mounting screws (flat head, M3 hex drive screws)
2. Make sure the rifle is unloaded and safe, then remove the rear sight.
3. Install your optic onto the mount using the M3 screws that came with your mount. Inspect the bottom of the mount to make sure the screws don’t protrude below the bottom of the mount far enough to impact the receiver (docter pattern sight pictured), then remote the optic from the mount.
4. Install the optics mount onto the rifle, using the included torx head screws. Do not exceed 8 in-lbs! Make sure the mount is installed with the correct end forward.
5. Install the optic onto the mount Do not exceed 4.5 in-lbs!
6. Perform a function check and make sure the rifle is safe to fire.